IMM 90-100

They are suitable for transferring liquids containing impurities up to 4 mm in size.
Their hydraulic components: impeller and feed screw in cast iron, pump body in steel allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel).
The temperature of the liquid must not exceed 90°C.

They are commonly used on:
– machine tools
– glass processing machinery
– surface treatment plants
– filtration systems
– spray booths

They are normally installed on a tank with a capacity which is proportional to their flow rate, about 7-8 cm from the bottom.
It is important to make sure that the maximum liquid level in the tank is always 5-6 cm lower than the support flange.
Should the liquid be particularly dirty, it is advisable to build a compartment tank in order to allow the sludge to deposit before it is sucked by the pump.