They are suitable for transferring liquids containing impurities up to 3 mm in size.
Their hydraulic components: impeller and feed screw in PBT, pump body in cast iron allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel).
The temperature of the liquid must not exceed 70°C.
They are commonly used on:
– machine tools (milling and turning machines)
– glass processing machinery (TRI version)
– surface treatment plants
– filtration systems
They are normally installed on a tank with a capacity which is proportional to their flow rate, about 3-4 cm from the bottom.
It is important to make sure that the maximum liquid level in the tank is always 3-4 cm lower than the support flange.
Should the liquid be particularly dirty, it is advisable to build a compartment tank in order to allow the sludge to deposit before it is sucked by the pump.